All water supplies contain minerals like calcium and magnesium that left untreated minerals in will deposit as scale along the length of the UV lamp quartz thimble and internal surface of the UV reactor chamber. As the coating of scale thickens the penetrating intensity of the UV light reducers and the reflective capacity of the UV reactor chamber are compromised decreasing the disinfecting capability of the UV system.
The Clean Water Co supply a UV system including hard water protection that reducers the build up of scale on the UV lamp quartz thimble and the internal surface of the UV reactor chamber allowing better UV light penetration and reflection into the water stream.
It is important to install the hard water protection on the UV system water inlet. In addition to the UV disinfection you will also enjoy a softer water with reduced hard water scaling problems.
UVG SLT125UV Disinfection SystemIncluding Outdoor IP65Power Supply
Maximum Flow Rates
- Potable Water – 126 litres per minute
- Non-potable Water – 169 litres per minute
The Powers of UV Disinfection
UV disinfection is a technology that uses Ultra-Violet light in the germicidal wavelength range between 200 and 300 nanometers. The optimum UV wavelength for UV disinfection is 264 nanometers which is located within the UV-C spectrum.
When microorganisms are exposed to germicidal wavelengths, they are destroyed outright or rendered incapable of reproducing. The high energy associated with UV-C UV light is absorbed by the DNA of bacteria, viruses, spores and other pathogens. This absorption causes abnormalities within the DNA to occur, resulting in the microorganism being incapable of reproducing and infecting.
A certain UV dose will provide a 99.9% reduction in bacteria
MAXIMUM FLOW RATE – 126 l/min @ 40mJ/cm2 FOR
- Town water supplies with 80% UVT (Ultraviolet Transmittance)
- Rainwater tank supplies with 90% filtered water UVT (Ultraviolet Transmittance)
MAXIMUM FLOW RATE – 169 l/min @ 30mJ/cm2 FOR
- Pond, irrigation and non-potable water treatment
- 316SS UV reactor with heavy duty poly mounting brackets
- Connections: 2” BSP male threads
- Dimensions: 99cm’s x 9cm’s
- IP65 Weatherproof controller
- Thermal Relief Valve
- Warranty: 1 year
- WaterMark Certified
UV LAMP REPLACEMENT FREQUENCY
UV Lamps should be replaced every 12 months.
T18 Water Conditioner With ¾” BSPT Female Fitting
Model : T100 with an average flow rate of 100 litres per minute
Best Installed On the inlet to the UV system water inlet.
Installation:To be carried out by a licenced plumber
Replacement Parts: None
Chemicals and Salt: None
Product Lifespan: At least 15 years
Warranty: 15 years
WaterMark Certified: Yes
Installation instructions are supplied with the UVG SLT125 & T100 mineral conditioner.